Black & Decker GH610 Replacement Accessories, AF-100, REPLACING THE SPOOL FIGURES 11,12,13

Models: GH610

1 38
Download 38 pages 27.55 Kb
Page 8
Image 8
REPLACEMENT ACCESSORIES

• If desired, pull the wire edge guide (m) out from the motor housing until it clicks

into the locked position as shown in figure 10 10 and position the trimmer above the surface as shown in figure 10.

• Return to the trimming position by loosening the lock collar and rotating the lower housing back 180°. The tool will lock in the trimmer position. When using the tool, retract the wire edge

guide to the original position,

out of the way.

m

CUTTING LINE / LINE FEEDINGREPLACING THE SPOOL (FIGURES 11,12,13) Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon line. During use, the tips of the nylon lines will become frayed and worn and the special self feeding spool will automatically feed and trim a fresh length of line. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut. The advanced automatic line feeding mechanism senses when more cutting line is needed and feeds and trims the correct length of line whenever itʼs required. DO NOT BUMP unit on ground in attempt to feed line or for any other purposes.

8

REPLACEMENT ACCESSORIES

Use Black & Decker replacement spool Model No. AF-100. Reload nylon line (either bulk or prewound replacement spool) as shown in this manual.

• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating. This line is available at your local dealer or authorized service center.

• Other replacement parts (guards, spool caps, etc.) are available through Black & Decker service centers. To find your local service locationWARNING:call: 1-800-544-6986 or visit www.blackanddecker.com.

The use of any accessory not recommended by Black & Decker for use with this tool could be hazardous.

REPLACING THE SPOOL (FIGURES 11,12,13)

 

• Unplug tool.

11

 

• Depress the tabs (n) and

 

o

remove the spool cap (o)

Replacement

from the spool housing (p) in

 

the trimmer head (figure 11).

spool

 

• For best results, replace

model no.

 

spool with Black & Decker

 

model no. AF-100.

AF-100

 

• Grasp empty spool with one

 

hand and spool housing with

n

n

other hand and pull spool

out.

 

 

p

Page 8
Image 8
Black & Decker GH610 instruction manual Replacement Accessories, AF-100, REPLACING THE SPOOL FIGURES 11,12,13