![](/images/new-backgrounds/1105716/10571611x1.webp)
capacity than 18 gauge. When using more than one extension to | ||||
make up the total length, be sure each extension contains at least | ||||
the minimum wire size. |
|
|
| |
CHART FOR MINIMUM WIRE SIZE (AWG)OF EXTENSION CORDS | ||||
| NAMEPLATE RATING AMPS – 0 – 10.0 |
| ||
Total Extension Cord | ||||
Length (ft) | ||||
Wire Gauge | ||||
18 | 16 | 16 | 14 |
9. Use only the supplied charger when charging your unit. The use of any other charger could damage the battery pack or create a hazardous condition.
10. Use only one charger when charging.
11. Do not attempt to open the charger or the unit. There are no customer serviceable parts inside. Return to any authorized Black & Decker service center.
12. DO NOT incinerate battery packs even if they are severely damaged or completely worn out.
13. Do not incinerate the batteries. They can explode in a fire. A small leakage of liquid from the battery cells may occur under extreme usage, charging or temperature
conditions. This does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical
attention.The liquid is a
IMPORTANTCHARGINGSAFETY
INSTRUCTIONS
CHARGING PROCEDURE
| THE BATTERY PACK IS NOT FULLYCHARGED AT THE | |
| FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS | |
| The charger is designed to use standard household 120 volt 60 Hz | |
| BEFORE USE. |
|
| power. |
|
| 1. Plug the charger into any standard 120 Volt 60 Hz electrical | |
| outlet. NOTE: Do not charge by means of an engine | |
| generator or DC power source. Use only 120V AC. | |
| 2. Slide the charger onto the battery as | 1 |
| shown in figure 1 and let the battery |
|
| charge initially for 9 h urs. After the |
|
| initial charge, under normal usage, your |
|
| battery should be fully charged in 6 to 9 |
|
| 2a) During charging the green LED will |
|
| hours. |
|
| appear. |
|
| 2b) When charging is complete the green |
|
| LED will go off. |
|
| 3. Unplug charger, and remove the battery pack. Place the battery | |
| NOTE: To remove the battery pack, press down on the release | |
| pack into the t ol until it “clicks” into place. | |
| button on the back of the battery pack and slide out. | |
| IMPORTANT CHARGING NOTES |
|
| 1. After normal usage, your battery pack should be fully charged in | |
| 6 to 9 hours. If the battery pack is | |
| take up to 9 hours to become fully charged. Your battery pack | |
| was sent from the factory in an uncharged condition. Before | |
| attempting to use it, it must be charged for at least 9 hours. | |
6 | 2. DO NOT charge the battery pack in an air temperature below | |
|
|