The unit must be disconnected from the mains supply and taken to an authorised service centre for repair.
The charger is intended for indoor use only.
Read the manual carefully before using the appliance.
Warning! Keep electrical appliances out of reach from children or infirm persons. Do not let them use the appliances without supervision.
Features
1.On/off switch 2.Dust bowl
Fig. A
3.Crevice tool 4.Brush tool
Unpacking
Identifying your product
The model design can be determined from the suffix codes used in the catalogue number. The following catalogue numbers are described in this manual: NV19XXY/NV24XXY/NV36XXY/ NV48XXY/NV60XXY/NV72XXY
The suffix code XX corresponds to the following designs:
00/99: stick handle, no accessories supplied
03:loop handle, supplied with crevice tool and brush tool
The suffix code Y is used to identify the range of colour options. The suffix code Y represented by the letter N is used for models with an NiMH battery.
Installation
NV24XXY/NV36XXY/NV48XXY/ NV60XXY/NV72XXY - Fitting the charging base to the wall
(fig. B1 & B2)
The charging base can be placed on
a worktop or fitted to the wall to provide a convenient storage and charging point for the appliance.
ENGLISH
Assembly
Fitting the accessories (fig. A & C)
Depending on the model, the appliance is supplied with the following accessories:
a crevice tool (3) for confined spaces
a brush tool (4) for furniture and stairs To fit an accessory, proceed as follows:
Take the accessories from the appliance.
Insert the appropriate accessory into the front of the appliance.
You may refit the other accessory by clicking it into the accessory holder. To refit both accessories:
Push the accessories down until they click into place.
Use
The appliance can be charged while placed on a worktop or hung on the wall using the wall hook provided.
Before first use, the battery must be charged for at least 16 hours.
Leave the appliance connected to the charger whenever it is not in use.
Charging the battery (fig. B1 - B3)
NV24XXY/NV36XXY/NV48XXY/ NV60XXY/NV72XXY (fig. B1 & B2)
Make sure that the appliance is switched off. The battery will not be charged with the on/off switch in the on position.
Fit the appliance properly on the charger aligning the arrow on the charger with the split of the appliance.
Plug in the charger. Switch on at the mains.
Leave the appliance to charge for at least 16 hours.
NV19XXY (fig. B3)
Make sure that the appliance is switched off. The battery will not be charged with the on/off switch in the on position.
Insert the charger plug (6) into the charger connector (7) at the rear of the appliance.
Plug in the charger (5). Switch on at the mains.
5