Chapter 2: Overview
|
| Table |
|
|
|
Number | Component | Description |
|
|
|
|
| The power switch turns the unit on and off. The LED will light red to indicate that the switch is on |
1 | Power Switch | and is receiving power. The switch will remember that last state during a power cycle. When |
|
| power is removed and restored, the last configuration will be used. |
|
|
|
2 | Output Status Display | Each output (destination) channel shows which input (source) is assigned. |
| Function Key — RECALL | |
| The system will show previously stored presets, up to a total of 16. Presets are stored in local | |
| memory using Source keys 1 through 8 or Destination keys 1 through 8 as the memory preset | |
| location. | |
3 | • Press the RECALL button. | |
• Press 1 through 8 in either Source or Destination row. | ||
| ||
| • Press ENTER. The preset configuration will execute. Operation completes. | |
| NOTE: Operation will abort if no keys are pressed within 5 seconds. |
Function
4
The system will store presets, up to a total of 16. Presets are stored in local memory using Source keys 1 through 8 or Destination keys 1 through 8 as the memory preset location.
•Configure desired matrices.
•Press the MEMORY button.
•Press 1 through 8 on either Source or Destination row.
•Press ENTER to ready memory location.
•Or press MEMORY again to cancel operation.
Operation completes.
NOTE: Operation will abort if no keys are pressed within 5 seconds.
Function Key — LOCK
5 |
| • Press and hold the LOCK button for two seconds to lockout the front panel. |
| • Press and hold the LOCK button for two seconds to | |
|
| |
|
|
|
6 | EDID Mode Select Buttons | Select EDID mode using Buttons #1 and 2. |
|
|
|
7 | Source Select Buttons | Separate inputs 1 through 8 select buttons are provided for each source selection. |
| Function Key — EDID |
| Press EDID to select new EDID mode and select source button #1 or #2 to change embedded EDID |
| mode. |
8 | Press the Destination number to learn EDID. The Destination EDID has been learned. |
| |
| Press the Destination number multiple times to switch between local and HDBaseT EDID. |
|
|
Page 11 |