KeyCard lost or damaged

THEFT PROTECTION

To “train” a new KeyCard in case of loss or damage:

➮Insert the first KeyCard and switch the device on.

➮Press the MENU button, 8.

➮Press the or button, 7, until “LEARN KC” appears in the display.

➮Press the button, 7.

“CHANGE” appears in the display.

➮Remove the first KeyCard.

➮Insert the new KeyCard. “LEARN OK” appears in the display. To leave the menu:

➮Press the MENU button, 8.

The radio can now be operated with the new KeyCard.

If all the KeyCards belonging to a device are damaged or lost, a new KeyCard will have to be “retrained” with the device’s master code. You will find this code in the device’s Car Ra- dio Passport.

Keep your Car Radio Passport in a safe place, but never in the car itself.

The instructions for this are in the section on “Training a new KeyCard / Entering the mas- ter code”.

Using this KeyCard, you can then “train” a second KeyCard. Please read the section on “Replacing / Training KeyCards”.

New KeyCards can be obtained from your dealer.

Training a new KeyCard /

Entering the master code

If you no longer have a valid KeyCard for your device, and would like to train a new KeyCard:

➮Insert the new, unknown KeyCard into the device.

➮Close the control unit.

➮If necessary, switch the device off.

➮Hold down the TUNE and ST1 buttons, >and 4, at the same time.

➮Switch the device on with the main but- ton, 2.

“0000” appears in the display.

Enter the four-figure master code from the Car Radio Passport as follows:

➮Enter each of the numbers for the mas-

ter code using the and buttons,

7, pressing until the desired number appears in the display.

➮To enter the next/previous digit, use the and buttons, 7.

➮When the master code is correctly dis- played, press the OK button, 5.

If the device switches to play, the new Key- Card has been accepted.

Visual theft protection (LED)

When the device is switched off and the Key- Card has been removed, the power button and the CD slot illumination can be set to flash. This is done by setting “LED” to “ON” in the menu.

➮Press the MENU button, 8.

➮Press the or button, 7, until either “LED ON” or “LED OFF” appears in the display.