Blaupunkt RCR 128 Important notes, What you need to know, Traffic safety, Installation

Models: RCR 128

1 18
Download 18 pages 38.56 Kb
Page 7
Image 7

Setting the tone:

Select the audio mode. Press AUD once and set the tone using the rocker switch.

Treble:

Treble +

Treble –

Bass:

Bass –

Bass +

Press AUD twice and set the fader using the rocker switch.

Fader front

Fader rear

Balance left

Balance right

The selected values will appear in the display. The last setting is stored auto- matically.

Switching AUD off

Press button briefly.

If you do not change the tone within 8 sec., the AUD mode will quit auto- matically.

Extra function: LD

Loudness boosts the bass frequency at low volume.

Press AUD longer than 2 seconds to change the Loudness setting. “LD” will appear.

Important notes

What you need to know

Before using your new car radio, please read through the following information carefully.

Traffic safety

As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times.

Never use your car radio in a way that could distract you.

Please keep in mind that you travel a dis- tance of 14 m per second at a speed of only 50 km/h.

Should the traffic situation become particu- larly demanding, we advise you not to use the radio.

Always make sure that you are still able to hear any warning signals coming from out- side the vehicle, such as police or fire en- gine sirens, so that you can react accord- ingly.

Consequently, you should always select a moderate volume for playing your car radio while you are driving.

Installation

If you would like to install your new car ster- eo yourself or add other audio components to existing ones, then please read the en- closed instructions on installation and con- nection carefully.

In order to ensure that the set operates prop- erly the positive power supply line must be connected via the ignition and the perma- nent +12 V lead.

Do not ground the loudspeaker outputs!

Warning note

Danger of damaging the automatic power antenna in a car wash

Before you drive into a car wash

switch the radio off by pressing the ON button.

The power antenna will retract, if it doesn’t, press ON again.

Do not drive into the car wash unless the power antenna has retracted!

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

23

Page 7
Image 7
Blaupunkt RCR 128 operating instructions Important notes, What you need to know, Traffic safety, Installation