INFRARED CHEESE MELTER | SERVICE |
ACCESS TO SERVICEABLE PARTS
Some serviceable parts are only accessible by removing body side panels and the front panel.
The main front panel is fastened with six
Figure 8
Access to Serviceable Parts
Burner Manifold
Body Side
Pilot Adjust
Body Side
Front Panel
Pressure Regulator
Burner Adjust Valve
If necessary (or convenient),
ADJUSTMENT OF CHEESE MELTER PILOTS
The pilots are adjusted at the factory. If later the pilots are
1.If necessary, light the pilots.
2.Locate the pilot adjustment screw (which adjusts both pilots). It is a small slotted screw located on the pilot valve, and is accessed though the plugged hole in the front panel above the
3.Turn the pilot adjustment screw to adjust the size of the pilot flames. The flame on each pilot should be large enough to extend along the flame carrier to the burner surface.
ADJUSTMENT OF LOW SETTING
The minimum gas flow to the burners is controlled by the burner valves. It provides an infinite variable adjustment from low to high. Turn the knob to the desired position so that when the Cheese Melter control knob is in the LOW position, the burner flames do not flutter or “pop,” but rather burn with a dull red or a blue haze.
INSTALLATION AND OPERATION MANUAL 1186533 REV 1 (02/06) | PAGE 19 OF 28 |