6Quick instructions for daily use

Preparation

1.Turn on both hot and cold water faucets fully. Check and be sure the water connection is tight.

2.Place the laundry in the drum.

3.Add laundry additives (e.g. detergent, fabric softener,bleach).

Starting

1.Press the “On/Off” button.

2.Select the appropriate wash cycle and temperature suitable for your items.

3.If required:

select any auxiliary function,

adjust the spin speed,

set the time delay,

4.Close the loading door.

5.Press “Start/Pause/Cancel” button.

The display shows the time remaining for the program to complete if time delay is not set.

6.Check if the program follow-up indicator on the screen lights up.

Canceling a program

1.Press and hold the `Start/Pause/ Cancel` button for about 3 seconds; the “Ready” light will start flashing.

2.The machine can drain all the water or can take in water for 3 times at most to cool down the clothes and complete draining process.

Adding more laundry

This is only possible under the following conditions:

1. during time delay,

C You may add or remove laundry during the time delay (until the program starts).

2.At the beginning of a washing cycle, C Machine allows adding more laundry during a future step only if the water

level is low enough to open the loading door or if the temperature in the machine is low

In order to add laundry after the start-up of the program:

1.Press “Start/Pause/Cancel” button. Wait for the safety lock to open. “Ready” lamp will light up continuously.

2.Open the loading door and put in more laundry.

3.Close the loading door.

4.Press “Start/Pause/Cancel” button.

Re-spinning the laundry

The control system for an unbalanced load can pause the spinning in cases when the distribution of the laundry in the drum is not balanced.

If you want to re-spin the clothes:

1.Rearrange the previously placed clothes in the drum.

2.Select the spin program.

3.Adjust the spin speed.

After the program is finished

Program indicator lights on the screen remain lighted up after the program is finished.

1.“End” will appear on the screen when “ready” lamp lights up in the program follow-up indicator. Open the loading door and remove the laundry.

2.Press the “On/Off” button.

3.Turn off the faucets.

4.Check the rubber door seal for any foreign objects.

5.Leave the door and dispenser drawer open to dry.

25

EN

Page 25
Image 25
Blomberg WM 67121 NBL00 installation instructions Quick instructions for daily use