gallons (8 liters) per minute flow rate with a fully open faucet. Water inlet hoses and valves should withstand a water pressure of 145 psi (10 bar) at maximum. If the pressure is higher than 145 psi, a
•Hot water supply temperature must not exceed 140˚F (60˚C). (Ideally 120˚F (48˚C))
•Do not connect the washer to an unpressurized water boiler since water pressure may not be adequate for proper operation.
•Do not remove the filters located on the water supply hoses (on faucet/hose and hose/inlet valve connections).
•Always use genuine “Blomberg” water supply hoses when connecting with this washer. Old or
not advised to extend inlet or drain hoses, if necessary consult your dealer or technical service about hose extensions.
•Hot and cold water faucets must always be easily accessible to the user.
•At the end of a washing day, turn off water faucets to prevent any leakage or water damage that may occur due to a faulty condition of the appliance.
•Check the appliance and inlet hose connections for water leakage after each use. If there is leakage, turn off the appliance and water faucets and call service.
•Check the water inlet and drain hose connections regularly for any leakage. Hoses should be replaced every 5 years.
•If there is no hot water supply, hot water valve must be connected to a cold water faucet nevertheless. Both water valves should be connected to water supply for proper operation of your washer.
Drainage
A WARNING - Drain hose should not be bent. Be sure that there are no kinks or cuts on it.
A WARNING - Drain hose outlet must not contact the drained water.
Drain hose may be connected into a sink, into the drain of a sink, to a standpipe and floor drain.
•When connecting into a sink, the drain hose should be placed at the edge of the sink and secured with the hose guide supplied by the manufacturer. Additionally, the guided hose may be tied to the water faucet with a strap for extra security.
•Drain hose may be connected into the drain of a sink . Be sure that the connection is safe and not leaking. An additional clip etc can be used for safe connection.
•Drain hose may also be connected to a minimum 1.26 in (32 mm) diameter stand pipe.
•Be sure to secure the drain hose tightly to the pipe (stand pipe, drain pipe/edge of the sink) with a strap etc.
•The hose should be placed between
16 and 39 in. (40 and 100 cm) from the floor level
•If you have floor drain system, you can place the drain hose in the hole located on the floor.
Installation Checklist
•Water inlet hoses and accessory bags must be removed from the wash drum.
•Transportation/shipping bolts must be removed.
13
EN
