12 EN
B WARNING – Be sure to unplug
the power cable before attempting
maintenance or cleaning of your
appliance to minimize the risk of
electric shock. Always unplug the
cable by grasping the plug, not the
cord.
B WARNING – Do not use wet hands
when plugging/unplugging the power
cable.
Power supply and circuit
Connect the clothes washer to the
junction box supplied. Junction box
must be connected to an earthed outlet
protected by a fuse of suitable capacity.
Important:
•Mainsconnectionshouldcomplywith
national regulations.
•Thevoltageandmaximumtotal
current are specified in the section
“Specifications”.
•Theappliancemustnotbedirectly
connected to the mains in case of
absence of junction box.
•Connectionviaextensioncordsor
multi-plugs should not be made.
B WARNING - A damaged power
cable must be replaced by a qualified
electrician.
B WARNING - The appliance must not
be operated unless it is repaired!
There is the risk of electric shock!
15 Amp. Fuse or circuit breaker, 208-
240 volt, 60 Hz, grounded, alternating
current
Properlygrounded3-prongreceptacle
and junction box to be located so the
power supply cords are accessible when
the washer is in installed position.
Water Supply Connection
Your���washercomeswithbothcoldand
hot water connections. Connect the
blue marked cold water supply hose to
the cold water inlet valve/faucet and the
red marked hot water intake hose to the
hot water inlet valve/faucet. Screw the
connecting bolts by hand and tighten
the connection properly using a plier.
Over tightening may cause damage on
bolted connection.
A WARNING – Be sure that the water
connection of this washer is handled
by a qualified service technician or a
plumber.
The washer has two bolted ½’’ water
supply hoses and ¾’’ female hose
connections that can be connected to
¾’’ hot and cold water faucets.
A WARNING – Be sure that water
supply hoses are not crushed and
they have no kinking, bulges or cuts
before the water connection.
A WARNING – Be sure that there
are rubber seals located on the
hose connections. These seals
and adjustable bolts ensure a safe
connection without leaking. After
the water connection is done, turn
on both water faucets slowly and
completely to check any water leaks.
The water pressure must be between
15-145 psi (1-10 bar) for the proper
operation of this washer. 1 bar
corresponds to more than 2.1 US