| Inlet hose connections may be | Be sure the strainers and rubber | |
| seals of the water inlet hoses are | ||
| leaking. | ||
| solid and securely fitted. | ||
|
| ||
|
|
| |
| End of the drain hose may be | Tightly attach the drain hose to the | |
| loosely inserted into the waste | waste pipe or sink (See “Installation | |
| pipe or sink. | Instructions, Drainage”). | |
There is water coming |
|
| |
| If the house drain pipes are clogged, | ||
from the bottom of the | House drain may be clogged. | ||
washer. | call a plumber for assistance. | ||
| |||
|
|
| |
| Filter cap of the drain pump may | Make sure that the pump filter cap is | |
| not be properly fitted. | tightly closed. | |
|
|
| |
|
| Internal hose connections (e.g. | |
| Hose connections inside the | dispenser hoses, drain system) | |
| washer may be leaking. | should be checked by a service | |
|
| technician. | |
|
|
| |
Washer fills with water | There may be hot water inside | For safety reasons, water should be | |
when a process is | |||
washer. | cycled in and out a couple times. | ||
cancelled. | |||
|
| ||
Time delay function | Door may not be closed properly. | Close the loading door. | |
does not work. | |||
|
| ||
|
|
| |
| Water level might be above the | Run “Drain” , “Spin” or “Drain&Spin” | |
| lower level of the door. | program. | |
|
|
| |
| Washer might be heating up the |
| |
| water or it may be at the spinning | Wait until the process is over. | |
The door will not open. | cycle. |
| |
|
| ||
| Due to electrical safety |
| |
| mechanism, the door can only be | Wait until the process is over. | |
| opened a few minutes after the | ||
|
| ||
| program has stopped. |
| |
|
|
| |
| Door is not properly closed/Door | Check for any bulky or large items | |
The door will not lock. | hinge is not aligned with lock | ||
obstructing the door to be closed. | |||
| switch. | ||
|
| ||
|
|
|
30
EN
