Bloomfield 9104A, 9102A owner manual Installation Instructions, Install Legs, Level The Unit

INSTALLATION INSTRUCTIONS

663 76061 Owners Manual for 9102A Single Satellite Brewer

INSTALL LEGS

The brewer is provided with adjustable legs. Be sure all four legs are securely screwed into the base of the brewer.

LEVEL THE UNIT

The adjustable legs allow the brewer to be leveled. Set the brewer in its ultimate operating location and check for level with a spirit level Adjust the brewer for level from front-to-rear, and from side- to-side. Be sure all four feet rest firmly on the counter.

PLUMBER’S INSTALLATION INSTRUCTIONS

IMPORTANT:

This equipment must be installed in accordance with the Basic Plumbing Code of the Building Officials and Code Administrators International (BOCA), and the Food Service Sanitation Manual of the Food and Drug Administration (FDA). Also, this equipment installation must comply with all local plumbing codes and ordinances.

IMPORTANT:

Brewer must be installed on a water line with a full-flow pressure between 20 psi and 90 psi.

NOTE: If water pressure varies greatly, or exceeds 90 psi at any time, a water pressure regulator must be installed. Plumbing installer must supply the regulator.

Brewer must be connected to a potable water supply. Bloomfield recommends not less than 1/4” copper tubing for installations of 12’ or less, and not less than 3/8” copper tubing for installations exceeding 12’. Brewer must be connected to a COLD water line.

NOTE: DO NOT use a saddle tap for this water line connection.

A shut-off valve must be installed between the main water supply and the brewer. Plumbing installer must supply the shut-off valve.

A1/4-turn ball valve is recommended. Brewer INLET FITTING is 1/4" Male Flare.

Fig. 3 Water Line Installation

Flush the water line before connecting to the brewer.

CAUTION:

Hazard from

Unstable Equipment

Rubber feet must be installed on each leg of the brewer. Legs must be adjusted so that all four feet rest firmly on the counter. Failure to properly install the feet can result in movement of the brewer, which can cause personal injury and/ or damage to the brewer.

Fig. 2 Adjustable Legs

IMPORTANT:

In some areas, local codes require a backflow preventer (check valve) to be installed on the inlet water line. If a back- flow preventer is used, you must install a water hammer arrester in the incoming line, between the backflow preventer and the brewer inlet, as far away from the brewer as space will allow. This will relieve the excessive back pressures that can cause faucet leaks and solenoid malfunctions.

NOTE:

While new-style brewers incorporate an internal strainer in the inlet solenoid, the provided "Y" strainer should be installed in the incoming water line for ease of servicing.

5