INSTALLATION INSTRUCTIONS (continued)
CAUTION:
Electric Shock
Hazard
Brewer must be properly grounded to a reliable earth ground to prevent possible shock hazard. Do not assume a plumbing line will provide such a ground. Electrical shock may cause serious injury.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
Refer to Electrical Specifications, page 1.
Brewer requires a dedicated
Model 9311 120/240 Volt AC, 50/60 Hz
IMPORTANT:
Initial
IMPORTANT:
Complete water line installation before connecting brewer to electrical power.
MAKE SURE THE FRONT PANEL "TANK HEATER" SWITCH IS IN THE OFF POSITION BEFORE CONNECTING BREWER TO ELECTRICAL POWER.
DO NOT turn the TANK HEATER switch on until the water tank is filled. Heating element must be completely submerged in water at all times. Damage to the brewer caused by operating the heating elements dry is NOT covered by warranty.
INITIAL SET-UP INSTRUCTIONS
Plumber’s and Electrician’s installation procedures must be completed before proceeding with the
Be sure all electrical connections are secure, and that all plumbing connections are secure and
1. CHECK BREWER FOR PROPER CONFIGURATION
Make sure spray disk gasket is in place INSIDE of spray head.
Make sure spray disk is properly installed. Check hot water faucet for proper operation.
2. FILL WATER TANK
Be sure TANK HEATER switch is OFF, then connect brewer to electric power.
Insert an empty brew chamber under the brew head. Place an empty satellite in position. Turn the VOLUME SELECTOR switch to 1 GAL.
Press START. Water will begin filling the tank. Repeat until water flows from the brew chamber. For initial
3.CHECK HEATING
Press TANK HEATER switch ON. Water in tank will heat to brewing temperature in approximately 30 minutes. When the water temperature reaches the brew temperature set point, the
Hold a suitable container under the hot water faucet, then open the faucet . Continue drawing water until all trapped air is expelled.
661 74415 9311 Single Satellite Brewer
6