Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Step 13 – Install Cylinder Access Panel

Line up holes on Latch with slots on Cylinder Shroud. Attach with (2) Latch Screws and (2) Latch Nuts.

Line up holes in Access Panel hinges with holes in recessed area of left leg. Attach each hinge with (2) Hinge Screws and (2) Hinge Nuts.

Swing Access Panel closed and slip Latch over panel hook and

snap shut.

Step 14 – Replace Engine Access Panel

Slide Igniter wire onto Igniter post.

Position Engine Access Panel back in place.

Secure Panel in place with 3 screws previously removed from side and bottom holes.

Note: Once you have successfully completed assembly steps 1-15 you are ready to begin operating your heater.

If you wish to permanently mount your heater to a deck or patio, use the 5/8” hole in the base to attach it to an anchor bolt.

11

Owner’s manual and assembly instructions: model 163010 natural gas outdoor patio heater

12/4/02

Page 12
Image 12
Blue Rhino 163010 owner manual Install Cylinder Access Panel, Replace Engine Access Panel