Contact
Do not return to place of purchase.
Note: Each dome section has a pin mounted in place in the rolled bottom edge. If necessary for proper alignment of dome sections, loosen each screw prior to further assembly and retighten after sections are aligned.
•With the large side facing up, slide a dome rib on to the same side of one dome section as the pin. Slide two dome sections together, allowing the exposed end of the pin slide into the rolled edge of the next dome section. Line up hole in dome with threaded hole in pin.
•Insert one Dome Screw and secure loosely.
•Repeat procedure to complete the assembly of all three sections.
•Slide Dome bolt through bottom check plate (with small center hump), being sure that the rolled edge faces down.
•Slide bolt from previous step through the center of the assembled dome sections, and be sure that the rolled edge of the check plate fits inside of the ends of the three Dome Ribs. Also be sure that the slots in the check plate line up with the holes on the dome sections.
•Slide the other check plate over the Center bolt with the rolled edge facing up, again making sure that the plate fits inside of the Ribs and the holes line up with those in the dome.
•Spin the medium nut all the way down the bolt, clamping all of the pieces in place, making sure that all of the humps fit inside one another.
•Fully tighten all of the screws in the rolled edge.
•Slide Dome Cap over Dome Bolt, lining up notches in cap with Dome Ribs. Thread on finial until tight.
Step 9 – Attach Dome to Emitter•Gently lay Heater on its side using one styrofoam end to prop up top half.
•Align holes in Dome with threaded studs in Emitter brackets.
•Secure Dome to Emitter using (3) Cap Nuts.
•Leave Heater on its side for next step.
The white ceramic cone in the top of the engine is an important piece. DO NOT REMOVE.
•Make sure angled side of Gas Clip pokes up through large hole in Platform.
•Tighten screw until Gas Line is held securely in place.
•Stand Heater upright.
Owner’s manual and assembly instructions: model 223600 outdoor patio heater | 1/15/03 | 10 |