Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Step 13 – Replace Engine Access Panel

•Slide Igniter wire onto Igniter post.

•Slide tab at top of Access Panel into slot in Emitter bottom.

• Rotate Panel down until holes line up at bottom.

• Secure Access Panel in place with thumbscrew.

• Replace Control Knob.

Step 14 – Install Igniter Battery

Note: This step is required only for models with electronic ignition.

•Remove battery cover cap by turning cap counterclockwise.

•Install (1) AA battery. Negative end of battery goes in first.

•Replace battery cover cap by turning cap clockwise.

Note: Once you have successfully completed assembly steps 1-14 you are ready to begin operating your heater.

Owner’s manual and assembly instructions: model 223600 outdoor patio heater

1/15/03

12