Contact
Do not return to place of purchase.
Step 4 – Insert Gas Line through Platform/AttachShroud Cover• Insert Gas Line up through large hole in Platform from underneath between center and left leg as shown in illustration.
• Slide Shroud Cover over Gas Line, then over Platform/Leg assembly until bottom of Shroud rests on Base.
Step 5 – Attach Engine to Post• Lay Engine Assembly on its side, using shipping carton for support.
• Remove and save Control Knob.
•Remove and save Engine Access Panel by unscrewing (1) black Thumbscrew from bottom of Access Door.
•Disconnect wire from Igniter by gently pulling wire from back of box.
•Align (4) holes in top of Post with (4) holes in bottom of Engine.
Note: One hole is at a different level than the rest. Make sure that all 4 holes line up properly.
• Insert (4) Small Screws enough to hold Engine in place. They will be fully tightened at the end of Step 7.
Note: Do not replace Engine Access Panel until Step 13.
Owner’s manual and assembly instructions: model 223600 outdoor patio heater | 1/15/03 | 8 |