Contact
Do not return to place of purchase.
WARNING
FOR YOUR SAFETY:
If at any time you are unable to light pilot and smell gas, wait 5 minutes to allow gas to dissipate before attempting to light heater.
WARNING
FOR YOUR SAFETY:
Do NOT touch or move heater for at least 45 minutes after use.Allow all burner elements to cool before touching.Caution: Do NOT attempt to operate heater until you have read and understand all precautions in section 1 “Safety First.”
Before Turning Gas Supply ON•Your heater was designed and approved for outdoor use only. Do NOT use it inside a building, garage, or any other enclosed area.
•Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or liquids.
•Ensure that there is no obstruction to air ventilation.
•Be sure all gas connections are tight and there are no leaks.
•Be sure the cylinder cover is clear of debris.
•Be sure any component removed during assembly or servicing is replaced and fastened prior to starting.
Before LightingView Hole | • Heater should be thoroughly inspected before each use, and by a |
| |
| qualified service person at least annually. |
•If relighting a hot heater, always wait at least 5 minutes.
•Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly specified by manufacturer.
| Pilot |
LOW | (Push in) |
| |
HIGH | OFF |
Pilot
LOW | (Push in) |
|
HIGHOFF
13
Note: This heater is equipped with a Pilot Light that allows for safer startups and shutdowns. Pilot must be lit before Main Burner can be started.
•Turn Cylinder Valve OFF.
•Push Control Knob IN and turn to OFF.
•Wait 5 minutes for any gas to clear.
•Turn Cylinder Valve ON.
•Open Viewing Hole by sliding cover to either side.
•Push Control Knob IN and rotate to Pilot position.
•Note - For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge air from gas lines before proceeding.
•Push Igniter button once. Pilot Light flame will appear and be visible through Viewing Hole.
•Release Control Knob after 30 seconds. Pilot Light will remain lit. If not, return to step 1.
Owner’s manual and assembly instructions: model 223600 outdoor patio heater | 1/15/03 |