BISTRO
6
–Before connecting the hand mixer to the mains, check that the speed control (1) is set to position «0».
USING THE MIXER
IMPORTANT: to prevent overheating of the motor, switch off the mixer after four minutes continuous operation and wait two minutes before continuing.
–Place the ingredients in a bowl. Ensure that the accesso- ries do not touch the base or sides of bowls made of glass or porcelain.
–Immerse the accessories in the mixture and select the appropriate speed setting (1). See the SPEED SETTINGS section.
–To avoid splashing, keep the accessories immersed in the mixture while mixing.
–When you have finished mixing, set the speed control (1) to «0» and disconnect the mixer from the mains.
–When you have finished using the mixer, place it on the rest (9) with its four
REMOVING THE ACCESSORIES
–Before removing the accessories, set the speed control (1) to «0» and disconnect the mixer from the mains.
–Press the accessory release button (2) to release the acces- sories. Hold the accessories by the shaft when doing so.
–Note: to safeguard your safety, the accessories can be released only if the speed control (1) is set to «0».
STOWING THE CORD
–The cord should be stowed back in the cord compartment
(6) when you have finished using the mixer.
–Swing out the crank (7).
–Using one hand to hold the mixer by its handle (11), use the other hand to turn the crank (7) until the cord is stowed back in the cord compartment (6).
CARE AND MAINTENANCE
–Disconnect the hand mixer from the mains before cleaning it.
–Do not use abrasive cleaners.
CLEANING THE ACCESSORIES
–Remove surplus mixture from the accessories using a rubber or plastic spatula.
–The accessories can be washed by hand; they are also dish- washer proof.
–Any other servicing should be performed by an autho– rized servicing representative.
CLEANING THE BODY
–Use a damp cloth only to clean the exterior surfaces of the mixer.
–Never immerse the motor unit, mains plug or cord in water: remember that this is an electrical appliance.
