CC880/LP880, SC8016 Operators Guide 25.0 | Domestic Dialling |
|
|
EN 16
25.0 Domestic Dialling
Use domestic dialling to call your mobile phone or a relative/friend in the event your control panel activated an alarm. Up to three different telephone numbers can be programmed for the control panel to call when an alarm occurs. Only your installer can program the system to report in the domestic format. However, the master code holder can change the telephone numbers at any time.
25.1Acknowledging Domestic Calls
When an alarm condition occurs, the system calls the first telephone number programmed. When you answer an incoming call, you hear the system emitting a siren tone followed by a pause and repeat continually for 2 min. (for example, siren tone, pause, siren tone, and pause).
If you do not acknowledge the call from the control panel during a pause between siren tones, the control panel hangs up after 2 min. and calls the next telephone number.
Pressing the [*] button for 1 sec. to 3 sec. during the pause acknowledges the call and no further calls are made for that event. If the call was successfully acknowledged, a tone of decreasing pitch is heard.
Table 14: Domestic Dialling Telephone Digits
Digit Required | Number To Program |
0 | 0 |
1 | 1 |
2 | 2 |
3 | 3 |
4 | 4 |
5 | 5 |
6 | 6 |
7 | 7 |
8 | 8 |
9 | 9 |
* | *1 |
# | *2 |
4 sec. pause | *3 |
Break | *4 |
25.2Programming Domestic Telephone Numbers
If your system is set up for domestic dialling, this function allows any master code holder to program telephone numbers the control panel calls in an alarm.
How to Program Telephone Numbers
1.Enter your four character master code, followed by [2] and the [#] button (for example,
[2 5 8 0 2 #]).
Three beeps are heard and the STAY and AWAY indicators flash.
If there are telephone numbers already programmed, they are displayed one digit at a time by the codepad indicators.
If there are no telephone numbers programmed, two more beeps are heard after entering this mode. These two beeps are normally heard after the last digit of the last telephone number is displayed.
2.Enter all digits for the first telephone number (for example, [9 6 7 2 1 7 1 7]).
As each digit is entered, the corresponding codepad indicators display.
3.If there is more than one telephone number to be programmed, press [*]. This inserts a break between the first telephone number and the second telephone number. If there is only one telephone number to be programmed, press the [#] button to exit this function.
4.Enter all the digits of the second telephone number (for example, [9 6 7 2 1 0 5 5]). As each digit is entered, the corresponding codepad indicators display.
5.After the last digit of the second telephone number is programmed, press the [#] button to exit this function unless a third telephone number is required. If there is a third telephone number to be programmed, press the [*] button to insert a break between the second telephone number and the third telephone number.
25.3Disable Domestic Dialling
To cancel domestic dialling (for example, you are moving and do not want the system to continue calling your mobile phone), enter the following sequence.
1.Enter your four character master code, followed by [2] and the [#] button (for example,
[2 5 8 0 2 #]).
Two beeps are heard and the STAY and AWAY indicators flash.
2.Press the [*] button followed by the [#] button (for example, [* #]).
The STAY and AWAY indicators are disabled.
Bosch Security Systems 6/04 920036O.OG.162
