Bosch Appliances D2071A manual PriPh#, Special Dialing Characters

D2071A Operations & Installation Guide 4.0 Program Record

Table 9:		Special Dialing Characters
Selection			Dialing Effect		Description
	B		(*) character		Accesses special
					telephone features.
	C		3-sec pause		While dialing, inserts a
					3-sec pause between
					digits.
	D		7-sec dial tone		Waits up to 7 sec for a
			wait		dial tone before dialing.
	E		(#) character		Accesses special
					telephone features.
	F		Alternates		Used when accessing
			between		some long-distance
			rotary and		carriers while using
			DTMF		rotary-dial phone lines.
	PriPh#
	Default:			Blank

Selections: 0 to 9, B to F, or Blank

Use to select the primary receiver telephone number. You can enter up to seven characters. Refer to Table 9 for other dialing character selections.

When programming the primary and alternate telephone numbers, ensure the primary telephone number is different from the alternate telephone number.

AltPri

Default:	Blank
Selections:	0 to 9, B to F, or Blank
Blank	No prefix or area code. A delay of
	up to 7 sec is automatically inserted
	in front of the prefix.

Use to select the prefix for the alternate receiver telephone number. You can enter up to nine characters. Refer to Table 9 for other dialing character selections.

AltPh#

Default: Blank

Selections: 0 to 9, B to F, or Blank

Use to select the alternate receiver telephone number. You can enter up to seven characters. Refer to Table 9 for other dialing character selections.

When programming the primary and alternate telephone numbers, ensure the primary telephone number is different from the alternate telephone number.

12 V Mode

Default:	Yes
Selections:	Yes or No
Yes	12 VAC, 20 VA, 60 Hz transformer
	operation.
No	24 VDC supply from an existing
	FACP.

Use to enable either the 12 V Mode or 24 V Mode.

Class B Mode

Default:	3
Selections:	1 to 3
1	Mode 1 not acceptable for
	stand-alone applications.
2	Mode 2 has restricted use for
	stand-alone applications.
3	Mode 3 is required for most
	stand-alone applications.

Use to program the operating mode for the Class “B” Supervisory Circuits (Zones 2 and 3).

For detailed mode specifications, refer to Section 2.3 Zones 2 and 3, Supervisory Circuits beginning on page 11 for installation instructions.

Retard Time

Default:	0
Selections:	0 to 90

Use to program the retard timer for the Class “A” Alarm Initiating Circuit (Zone 1). Enter the number of seconds you want for the retard time. After an alarm condition is detected on the sensor loops, the retard timer starts. An Alarm Report is not transmitted until the retard timer reaches the value entered in Retard Time. If the faulted condition restores before the retard timer reaches the value entered in Retard Time, the Alarm Report is not transmitted.

Refer to Section 2.2.2 Retard and Reset Times on pages 10 and 11 for details. Refer to the appropriate NFPA Standard or the local AHJ for acceptable retard times.

Bosch 09/04 74-06200-000-F 2 1