Bosch Appliances DVRXEAP01 Configuration, Configuring the Bridge for a Network Connection

ATM/POS Bridge Configuration en 15

5Configuration

You must configure the ATM/POS Bridge network settings to ensure proper communication on an existing TCP/IP network. This section provides configuration details using the Web-based interface.

To configure the bridge using a HyperTerminal session, refer to Section 6 Configuration Using HyperTerminal, page 24.

For instructions to update the ATM/POS Bridge firmware, refer to Section A Updating Bridge Firmware, page 36.

5.1Configuring the Bridge for a Network Connection

The ATM/POS Bridge allows two methods to configure network settings:

–Use the Bridge Detector utility (supplied on the CD-ROM) to set the network settings (the Device Detection parameter must be set to Enable, refer to

Section 5.2.2 Network Setup, page 19). or

–Use a cross-over Ethernet cable to allow an APIPA-enabled workstation to connect to the bridge. The default network setting for the bridge falls within the APIPA address ranges.

5.1.1Using the Bridge Detector Utility

NOTICE!

Contact your local network administrator for a valid IP Address, Subnet Mask, and a Gateway IP Address.

1.Connect the supplied DC power adapter unit to the DC power input connector of the bridge.

2.Connect the RJ45 connector of the bridge via a straight Ethernet CAT5 network cable to a network switch or hub that supports 10BaseT.

Bosch Security Systems, Inc. Installation Manual F.01U.171.816 1.0 2010.09