![](/images/new-backgrounds/1165613/16561347x1.webp)
24 en Configuration Using HyperTerminal | ATM/POS Bridge |
|
|
6Configuration Using HyperTerminal
You can configure the ATM/POS Bridge via a PC HyperTerminal session. The PC is connected to the COM 3 (console) port on the bridge via a serial connection.
For instructions to update the ATM/POS Bridge firmware, refer to Section A Updating Bridge Firmware, page 36.
6.1Connecting the Bridge
1.Ensure that the bridge is connected to the power supply.
2.Connect the supplied console cable to COM Port 3 (console) on the bridge.
3.Connect the other end of the console cable to a serial port on the PC.
6.2Initiating a HyperTerminal Session
1.Launch the HyperTerminal application on the PC. This application is usually found on the Windows Start menu under the Programs
2.Type a name for the new HyperTerminal session and select an icon for the session, then click OK.
3.Select the appropriate COM port number on the PC that is connected to the bridge, then click OK.
F.01U.171.816 1.0 2010.09 | Installation Manual | Bosch Security Systems, Inc. |