10 en Installation | |
|
|
3Installation
3.1Initial Preparations
–Determine the operating voltage at the installation site.
–Determine the optimum location for the camera. Refer to Section 3.4 Mounting the Camera Housing.
–All units have been tested prior to shipment. After the wiring has been reconnected, check the unit’s operation before installation.
–Follow these installation steps in sequence:
Installation Step | PAGE |
Faceplate Removal | Page 10 |
Input Power Connections | Page 12 |
Mounting the Camera Housing | Page 13 |
Camera - Directional Adjustment | Page 15 |
LED Adjustments | Page 16 |
Camera | Page 18 |
3.2Faceplate Removal
You must remove the faceplate prior to installation in order to reach the mounting holes. You may need to change the directional angle of the lens. Refer to Figure 3.1.
1.Place the camera housing on a flat surface.
2.Use the supplied hex key to remove the six screws holding the faceplate into the housing.
3.Remove the square foam cushion attached to the camera lens.
F.01U.172.707 3.0 2011.02 | Instruction Manual | Bosch Security Systems, Inc. |
