Bosch Appliances EX36N instruction manual Camera Re-assembly, Photocell Foam pad

18 en Installation Corner-mount No-grip Camera

3.8Camera Re-assembly

1.Ensure that all wires are properly connected, that all holes are sealed against moisture penetration, and that all mounting screws are tight.

2.Slide the square foam pad over the camera’s lens. Ensure that the pad is as close to the faceplate viewing window as possible and the photocell is not covered by the foam pad. The foam pad is not symmetrical. Ensure that the LEDs are not covered when installing the pad.

3.Re-attach the faceplate with the six tamper-resistant screws. Tighten screws carefully, but do not overtighten.

4.Power up the camera and check its operation. Refer to Figure 3.8 below.

Figure 3.8 Camera Re-assembly

Number Description

1Photocell

2 Foam pad

F.01U.172.707 3.0 2011.02 Instruction Manual Bosch Security Systems, Inc.