Removing the door cover
The oven door cover can become discoloured. To carry out thorough cleaning, you can remove the cover.
1.Open the oven door fully.
2.Unscrew the oven door cover. To do this, undo the left and right screws (figure A).
3.Remove the cover (figure B).
6.Pull the lower panel at an angle, upwards and out.
7.Do NOT unscrew the left and
:Clean the panels with glass cleaner and a soft cloth. Risk of injury!
Scratched glass in the appliance door may develop into a crack. Do not use a glass scraper, or sharp or abrasive
Make sure that the oven door is not closed while the cover is removed. The inner panel may be damaged.
Clean the cover with a
4.Replace the cover and secure it in position.
5.Close the oven door.
Removing and installing the door panels
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "top right" is upside down at the bottom left of both panels.
1.Insert the lower panel at an angle towards the back (fig. A).
2.Slide in the middle panel (fig. B).
To facilitate cleaning, you can remove the glass panels from the oven door.
When removing the inner panels, pay attention to the sequence in which the panels are removed. In order to reassemble the panels in the correct sequence, use the numbers that appear on each panel.
Removal
1. Detach the oven door and lay it on a cloth with the handle |
facing down. |
2. Unscrew the cover at the top of the oven door. To do this, |
unscrew the left and right screws (fig. A). |
3. Lift the top panel up and pull it out and remove the two small |
seals (fig. B). |
3. Stick the retaining clips onto the right and |
the panel, aligning them so that the retaining carriers are over |
the screw holes, and then screw into place (fig. C). |
4. Hook the seal in to the bottom of the panel again (fig. D). |
4.Unscrew the retaining clips on the right and left. Lift the panel and remove the clips from the panel (fig. C).
5.Remove the seal from the bottom of the panel (fig. D). Pull the seal and remove it up and out. Pull out the panel.
5. Insert the uppermost panel at an angle to the back into the |
brackets. Take care not to push the seal to the back (fig. E). |
6. Insert the two small seals on the left and right of the panel |
again (fig. F). |
19 |
