Juniper Networks IDP75, IDP250, IDP8200, IDP 800 manual Install a Hard Drive

Chapter 7: Servicing the Device

To remove a hard drive:

1.On the front of the device identify the hard drive you want to remove.

2.Locate the blue release latch on the right side of the drive. (See Figure 20.)

Figure 20: Hard Drive Latch in Closed Position

3.Press and hold down the latch to release the handle, and then pull the handle open.

4.Use one hand to hold the drive from underneath and the other hand to remove the drive completely from the bay.

Install a Hard Drive

To install a hard drive:

1.Unclip the latch on the right side of the handle.

2.Open the handle to its fully extended position.

3.Begin to slide the drive into the bay.

4.Gently slide the drive the rest of the way into the bay and snap it into place.

5.Close the drive handle up until the latch clicks into place.

After a few moments, the warning noise ceases. The red failure LED on the new drive begins to flash, indicating that the hard drive is rebuilding. Then the hard drive activity LED on both drives will flash, indicating activity on both drives.

When the red failure LED stops flashing, the hard drive is rebuilt. Rebuilding the hard drive could take 30 minutes or longer.

CAUTION: Leave both drives in place until the hard drive array is rebuilt. Removing either drive while the hard drive array is rebuilding can damage the system.

Replacing a Hard Drive (IDP 800 and 8200 Only) „ 41