Juniper Networks IDP8200, IDP250, IDP 800, IDP75 manual Mounting Using Midmount Brackets

Chapter 3: Installing the Sensor

Figure 9: Rail with Hinged Rear Bracket

2.Rotate the hinges on both rails so that they allow the device to slide into the rack.

3.Slide the chassis into a set of rails.

CAUTION: Be sure to leave at least two inches of clearance on the sides of each chassis for the cooling air inlet and exhaust ports.

4.Secure the front brackets to the rack.

5.Rotate the rear brackets so they prevent the device from sliding forward.

6.Secure the rear brackets to the rack.

Mounting Using Midmount Brackets

To mount the sensor using the midmount brackets in a device rack:

1.Use a flathead screwdriver to attach one rack-mounting bracket to each side of the chassis with the bracket screws. See Figure 10 and Figure 11.

Figure 10: 2 RU Device Midmount Bracket

Rack Mounting the IDP Sensor „ 19