Juniper Networks IDP250, IDP8200, IDP 800, IDP75 manual Chapter

IDP 75, 250, 800, and 8200 Installation Guide

	Mounting Using Device Rack Rails	18
	Mounting Using Midmount Brackets	19
	Connecting Power	20
Chapter 4	Configuring the IDP Sensor	21
	Initial Configuration Options	21
	Simple Configuration	21
	Simple Configuration Settings	21
	Simple Configuration Values	22
	Advanced Configuration	22
	Connecting to the Sensor	22
	Using the Console Serial Port to Configure the Sensor	22
	Using the Management Port to Configure the Sensor	24
	Connecting Directly Using the Management Port	24
	Connecting Remotely Using the Management Port	25
	Simple or Advanced Configuration Using the Management Port	25
	QuickStart Simple Configuration	26
	ACM Advanced Configuration	26
	Connecting Forwarding Interfaces	28
	Verifying Traffic Flow	28
	Connecting the High Availability Port	28
Chapter 5	Adding the Sensor to NSM	29
	Adding Your Sensor to NSM	29
	Checking the Status of Your Sensor	33
Chapter 6	Updating Software on the Sensor	35
	Updating IDP Sensor Software Using NSM Firmware Manager	35
	Loading a Sensor Image into NSM	35
	Upgrading Sensor Software	36
	Updating IDP Sensor Software Without NSM	36
	Reimaging the IDP Sensor	37
Chapter 7	Servicing the Device	39
	Replacing a Power Supply (IDP 800, and 8200 Only)	39
	Remove a Power Supply	39
	Install a Power Supply	40
	Replacing a Hard Drive (IDP 800 and 8200 Only)	40
	Remove a Hard Drive	40
	Install a Hard Drive	41
Chapter 8	Advanced Configuration	43
	Advanced Deployment Modes	43
	Bridge Mode	43
	Router Mode	45
	Proxy-ARP Mode	46
	IDP High Availability Deployment Modes	46
Appendix A	Specifications	47
	IDP 75 Technical Specifications	48
	IDP 250 Technical Specifications	49

iv„ Table of Contents