Operation �TS ��� 15
en
5.7Software update
The software update is performed either using the "ESI[tronic] Startcenter" DVD or "Online".
!!Only perform the software update for a licensed KTS 340. The USB link and the power supply to the KTS 340 must not be interrupted during the software update. In addition, Standby mode on the PC/laptop must be deactivated.
iiThe ESI[tronic] Startcenter DVD 1 (annual basic ver- sion) must be installed using the "Software update by way of DVD" function.
iiYou can find the online help for the software update in the ESI[tronic] Startcenter under "Help >> Help".
iiIf the software update of the KTS 340 was aborted (e.g. USB link was interrupted) or installation was incomplete, you can perform a recovery in the ESI[tronic] Startcenter under "Help >> Customer Service" in the menu "Restore KTS software" (see ESI[tronic] Startcenter online help).
5.7.1Online software update (from ESI[tronic] Startcenter version 2010/2)
1.Start the "ESI[tronic] Startcenter".
2.Open the "Settings >>Online updates" input box.
3.Enter the customer number and password and select <Next>.
iiIf "Login" is not possible, check proxy settings under "Settings >> User settings".
4.Select an available update and start the software update.
5.Follow the
iiTo successfully conclude installation, restart the PC/laptop.
KTS 340 software update
1. Disconnect the power supply unit and USB connect- ing cable from the KTS 340.
2. Start the "ESI[tronic] Startcenter".
3. Supply power to the KTS 340 once more with the power supply unit.
??The KTS 340 starts up.
??The start screen "Vehicle identification" appears.
4. Connect the KTS 340 to a PC/laptop by means of the USB connecting cable.
5. ESI[tronic] Startcenter: Open "KTS 340 >> Device information".
6. Select an available update
7. Select <Update>.
""The system software is installed on the KTS 340.
5.7.2Software update using the ESI[tronic] DVD
Step 1: Installing ESI[tronic] Startcenter
1.Close all open applications.
2.Insert the "ESI[tronic] Startcenter" DVD.
3.Open the "Windows Explorer".
4.Start D:\setup.exe (D = DVD drive).
??Setup commences.
5.Follow the
iiTo successfully conclude installation, restart the PC/laptop.
Step 2: KTS 340 software update
1.Disconnect the power supply unit and USB connect- ing cable from the KTS 340.
2.Start the "ESI[tronic] Startcenter".
3.Supply power to the KTS 340 once more with the
power supply unit.
??The KTS 340 starts up.
??The "Vehicle identification" dialog box appears.
4.Connect the KTS 340 to a PC/laptop by means of the USB connecting cable.
5.ESI[tronic] Startcenter: Open "KTS 340 >> Device information".
6.Select an available update
iiIf no "available update" is displayed, the KTS 340 already has the current software and does not need to be updated.
7. Select <Update>.
""The system software is installed on the KTS 340.
5.8Faults
No communication with the control unit
The fault message "No system found" appears during control unit diagnosis.
Possible causes | Action to be taken |
|
|
Incorrect cable | Check that the correct cable has been |
connected. | used. |
Wrong pin selected in | Check which pin must be used in "Diag- |
pin selection menu. | nostic socket". |
iiIf problems of a different nature occur, please con- tact the ESI[tronic] Service Hotline directly.
Robert Bosch LLC | 1 689 989 072 |
