Bosch Appliances LTC 9385 Lens Wiring, Camera/Lens Orientation, Camera/Lens Adjustment

LTC 9385 Series Instruction Manual Installation

	BNC Connector
Video Coax Cable		CCD Camera

Small Fitting

Video Coax Cable		CCD Camera
	BNC Connector

Small Fitting

FIGURE 11 Video Coax Connection

5.10Lens Wiring

WARNING: Only use the cables specified under INSTALLATION, Cable Requirements for wiring of the lens.

If installing a zoom lens, insert the lens control cable with installed flexible fitting in through the fitting on the right rear of the base assembly. Attach the lens wiring to the lens mating connector and connect it to the lens. If mating connector is not available, connect directly to the lens cable. Pull any excess cable through the liquid-tight fitting and tighten the flex fitting to 8.5N-m to 9.0N-m (75in. lb to 80in. lb). This torque rating is approximately 1 to 1 1/2 turns past finger-tight, depending on the size of the wire. Failure to do so will result in water damage to all electronic parts. Use a tie wrap (included) to provide strain relief on the lens control cable at the exit point (inside the unit). See FIGURE 12.

NOTE: See specification on the lens cord for correct plug connection.

Be sure to securely tighten all fittings to ensure a liquid-tight seal. Not doing so could damage the camera, the housing, or both.

EN 13

If using a pan/tilt with a feed-through cable, insert the camera/lens function cable in through the right fitting at the rear of the cradle. Wire the functions as described above, or as needed.

5.11Camera/Lens Orientation

A unique feature of the LTC 9385 Series housing is the ability to rotate the mounting base 360º around the rail assembly.

Simply loosen the three M4 screws with a M3 hex wrench. Rotate the base assembly around the rail assembly to any position and tighten the M4 screws. It is preferable to keep the rail assembly under the camera, not over it. See FIGURE 13.

NOTE: Make sure the breather hole is located at the bottom of the housing. If it is not, remove both front retaining rings and the face plate. Orient them so the breather hole is located at the bottom and the gaps in the retaining rings are centered over the breather hole. See FIGURE 20.

Base Assembly

M4 Screws

FIGURE 13 Base Assembly Rotation

5.12Camera/Lens Adjustment

Lens Control Cable

CCD Camera

Lens Control Connectors

CCD Camera

Before final assembly of the cover over the rest of housing, verify camera and lens operation. Adjust camera/lens as necessary. See individual camera instructions.

FIGURE 12 Lens Control Cable Wiring

Bosch Security Systems January 26, 2005