4 of 12ISSUED: 06-25-99 SHEET #: 039-9003-8 02-08-05
E
Z
P
R
Y
Y
R
P
Attach support tray (A)
to vertical support arms
(P) as shown.
Note: Choose the square
hole which aligns closest
with the center of gravity
mark on the TV (as
determined in step 1).
Attach anti-rollout hooks
(R) as shown using M6
screws (Z) and retainer
bars (Y). Note: Extruded
side of retainer bar (Y)
goes towards anti-rollout
hook (R).
Hand tighten only.
A
Although top clamps (Q) and anti-rollout
hooks (R) [see step 7] will provide more than
adequate support for the TV, some installers
may wish to also attach the support tray to
the TV bottom.
Using uni-clips (G) and M5 screws (F) (see
instruction card in fastener pack), or #10 x
3/4" particle board screws (H) and washers
(I) (for attachment to mounting bosses if
present), or a combination of both, attach
support tray (A) to TV bottom. [To do this
place TV upside down on a flat stable
surface and position support tray upside
down on TV bottom.] Attach at four places
as close to the four corners of the TV bottom
as possible.
O P T I O N A LG
F
H
TV BOTTOM
A
TV
(UPSIDE DOWN)
Y
R
J
I