![](/images/new-backgrounds/1249031/24903121x1.webp)
Flush Mount Ceiling Kit | Installing the Recessed Camera Mount en | 7 |
|
|
|
5.Loosen the three
(Figure 2.2, item 4) by pulling it off of the base.
6.Remove the Inner Liner (Figure 2.2, item 3) by removing it from the Camera Module/Base.
7.Loosen the three Phillips head screws that secure the Camera Module/Base (Figure 2.2, item 2) to the Mounting Plate (Figure 2.2, item 1). Do not remove the hex-head screws.
8.Detach the safety tether. Set the Mounting Plate aside.
9.Remove the three screws securing the Recess Trim Ring to the Recess Bracket. Set the screws and the Recess Trim Ring aside.
10.Align the holes in the Recess Bracket and the Mounting Plate. Attach the Mounting Plate to the Recess Bracket, (item 5, below) using the three #10 Flat Washers and the three #10-24x1/2 in. Phillips Head Screws.
Figure 2.3 Attach mounting plate to backplate
11.Back the toggle bolts off the support screws until they are close to the end of the threads.
12.Run the power and the network cable (from the ceiling) through the slot in the Recess Bracket.
Bosch Security Systems, Inc. | Mounting Guide | F.01U.126.944 1.0 2009.04 |