12 en | Installing the Recessed Camera Mount Flush Mount Ceiling Kit
F.01U.126.944 | 1.0 | 2009.04 Mounting Guide Bosch Security Systems, Inc.
2.3 Mounting the AutoDome Analog/IP Camera
1. Determine a secure location for the flush mount ceiling kit.
Refer to Table 2.1, Page 4, for weight information.
2. If the ceiling tile is too thin or if it requires extra support,
refer to Section 2.1 Installing the VDA-NWDSKT Bracket,
Page 5.
3. Remove the Recessed Bracket and the template from the
VDA-NWDFMT packaging.
4. Mark the ceiling tile along the perimeter of the template;
then cut the ceiling tile along the template mark.
5. Remove the three screws securing the brass rings from the
underside of the AutoDome Easy camera (item 1, below).
You will not need the screws or the brass rings for this
installation, but retain these items for future applications.
Figure 2.9 Remove brass rings from AutoDome Easy
!
WARNING! The ceiling tile or the drywall must be between
6–23 mm (.24–.91 in.) thick.