VideoJet X40

Configuration Using a Web Browser en 81

 

 

5.29.1Multicast address video 1 to Multicast address video 4

Enter a valid multicast address for each stream from the relevant encoder (video input) to be operated in multicast mode (duplication of the data streams in the network).

With the setting 0.0.0.0 the encoder for the relevant stream operates in multi-unicast mode (copying of data streams in the unit). The VideoJet X40 supports multi-unicast connections for up to five simultaneously connected receivers.

NOTICE!

i Duplication of data places a heavy demand on the unit and can lead to impairment of the image quality under certain circumstances.

5.29.2Port

Assign a different port to each data stream if there are simultaneous data streams at the same multicast address.

Enter the port address of the required stream here.

5.29.3Streaming

Click the checkbox to activate multicast streaming mode for the relevant stream. An enabled stream is indicated by a check mark.

5.29.4Multicast packet TTL

You can enter a value to specify how long the multicast data packets are active on the network. This value must be greater than one if multicast is to be run via a router.

Bosch Security Systems

Installation and Operating Manual

V3.5 2007.12