Bosch Power Tools PR20EVSK, PR20EVSNK PR007 SIDE-HANDLE Subbase Available as optional accessory

BM 2609140437 05-06 5/23/06 3:15 PM Page 19

3.The overlapping piece of laminate should overlap the guiding piece by about 1/2". (The overlapping sheet of laminate will then pass over the aluminum plate and be cut at the proper point by the router bit.)

4.Keep steady pressure on the tool so that the guiding edge of the base remains in contact with the fixed piece of laminate throughout the operation. This is especially important at the beginning and end of a cut.

5.It is also necessary to keep the laminate pressed down tightly near the seam to keep these chips from getting under the laminate. This is especially important on larger pieces of material. The optional PR007 Side Handle Subbase includes a dust extraction hood port that connects to a vacuum hose and helps to keep chips from getting under the laminate.

PR007 SIDE-HANDLE SUBBASE (Available as optional accessory)

See PR007 instruction sheet for complete information about this accessory.

The PR007 Side-Handle Subbase and Dust Extraction Kit (Fig. 35) is a versatile accessory that provides several useful features:

•Additional means of supporting the router

•Dust extraction and collection capability

PR007 Attachment to Palm Router

1.Remove regular subbase

2.Attach side handle subbase with the panhead screws that are included with it.

Additional Means of Supporting

the Router

The knob handle on the PR007 subbase provides an additional gripping point for the palm router / side-handle subbase assembly. It is designed for use when the palm routers are being used in applications that are wide enough that the knob sits over the workpiece. Holding the knob and keeping it pressed down over the workpiece helps keep the routers’ angle to the workpiece unchanged, and is especially helpful when routing edges.

Attachment of PR006 Underscribe

Attachment

The PR006 Underscribe Attachment can also be used with the palm router and the side- handle subbase.

Note: When the underscribe attachment is used with the side-handle subbase, the longer set of attachment screws should be used.

Please refer to PR006 Underscribe Attachment section for further instructions.

Dust Extraction & Collection Capability If you have a shop vacuum system, you can connect it to the PR007’s dust extraction

FIG. 35

attachment to remove routing dust and debris for enhanced utility, visibility and accuracy.

The dust collection capability of the PR007 can be used in both common types of router applications:

1.Routing on flat surfaces

2.Edge-forming

!WARNING To reduce the risk of injury, do not reach in area

of the bit while the router is ON or plugged in. To avoid entangling hoses, do not use this dust extraction hood at the same time as any other dust extraction hood.

Dust Extraction when Routing on

Flat Surfaces

Attach the dust port on the back end of the subbase.

1.Position the port on the backside of subbase

2.Affix using two thumbscrews included.

Dust Extraction when Edge-forming

Attach the dust hood and port on the back end of the subbase.

1.Position the hood on the backside of subbase

2.Position the port on the backside of the dust hood.

3.Affix using two thumbscrews included.

-19-