6.0 E4 System Setup
Programmer’s Note: If this process fails, a dialog similar to the following will appear. Check the sensing microphone installation and make sure all sources are operating.
10.At the end of a successful Auto Volume calibration, the soft- ware displays a list of controls that are disabled when Auto Volume is on. Click Finish to exit Auto Volume Setup. The Auto Volume function is now On.
Following a successful microphone calibration, the software | Resetting a calibrated Auto Volume zone | ||||
automatically flashes the hardware to save the configuration. | |||||
| To cancel the calibration in an Auto Volume zone, click the Reset | ||||
| button. The Reset button is available only after a zone is suc- | ||||
| cessfully calibrated. | ||||
| When you reset a calibrated Auto Volume zone, the keypad con- | ||||
| trol programming is restored to that of a Standard Wall Plate the | ||||
| next time you perform a hardware flash. | ||||
|
|
|
|
| Programmer’s Note: Be sure you want to reset the |
|
|
|
|
| zone before you click the Reset button. If you reset the |
|
|
|
| ||
|
|
|
| ||
|
|
|
|
| zone, you will need to run the Auto Volume setup process |
|
|
|
|
| |
|
|
|
|
| again before you can use Auto Volume. |
|
|
|
|
| |
Click to reset Auto Volume calibration
57 of 80
