Preparing the Remote

Getting the remoteP epa ing the R oteready to use

You can use your RC-18S remote control as soon as the batteries are installed. It is pre-set at the factory for use outside the main room where your LIFESTYLE® system is located, in an area where another Bose® system or speaker pair is set up.

Or, you can use it as a secondary remote in the same room with the LIFESTYLE® system instead. To learn how to set switches inside the battery compartment for that purpose, refer to “How to change the settings, as needed” on page 15.

To install batteries

1.Slide the battery cover off the back of the remote.

Note: You may notice the small switches just above the batteries inside the compartment. These are the house code, stream selection, and room code switches, explained on page 12.

2.As you install the four supplied batteries, match the polarity markings (+ and –) on each one to markings inside the battery compartment (Figure 2).

Figure 2

Polarity marked on

+

+ +

the batteries

 

+

3.Slide the battery cover back into place until it snaps closed.

Note: If you notice a decrease in the range or response of the RC-18S remote control, the batteries may need to be changed.

English Dansk Deutsch Español Français Italiano Nederlands Svenska

7

Page 7
Image 7
Bose RC-18S manual Preparing the Remote, Getting the remoteP epa ing the R oteready to use, To install batteries