34
Turning the Power On/Off
Once the connections have been completed (p. 32), turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1
Check the following before you turn on the power.
❒
Have connections with your external equipment
been made correctly?
❒
Are the volume controls of the BR-800 and the
connected equipment set to the minimum position?
❒
Is the SD card inserted? (p. 146)
2
Lower the BR-800’s [MASTER] fader.
fig.P-On01.eps
3
Switch on the power to the equipment connected to
the input jacks (GUITAR/BASS, INPUT, LINE IN).
4
Turn on the [POWER] switch located on the side
panel.
fig.P-On02.eps
5
Switch on the power to the equipment connected to
LINE OUT jacks.
1
Make sure that song playback is stopped.
2
Turn off your equipment in the reverse order of when
you turned them on.
3
Make sure that the BR-800’s display does not indicate
“Keep power on!”
4
Turn the BR-800’s [POWER] switch off.
Turning the Power On
Turning the Power Off
• Make sure that the recorder is stopped before you
switch off the BR-800’s power. If you turn off the
power during recording or playback, the data,
mixer settings, or effect patch data will be lost.
• When using the AC adaptor, take care that the AC
adaptor is not unplugged during use. Data may be
lost if the AC adaptor is unplugged during
operation.
• When powering the unit on power from a USB
bus, exercise due caution in preventing the USB
cable from being disconnected during use of the
unit. You risk damaging your data should the
USB cable get disconnected.
• Turning the power off while the display indicates
“Keep power on!” will result in loss of data. Never
turn off the power while this indication is shown.
• This unit is equipped with a protection circuit. A
brief interval (a few seconds) after power up is
required before the unit will operate normally.
• When the BR-800 is shipped from the factory, an
SD card is inserted in the MEMORY CARD slot.
• Always make sure to have the volume level
turned down before switching on power. Even
with the volume all the way down, you may still
hear some sound when the power is switched on,
but this is normal, and does not indicate a
malfunction.
• Do not touch the buttons while turning on the
BR-800’s power.
The unit might malfunction if you turn on the
power while touching a button.
BR800_e.book 34 ページ ２０１０年１１月２日 火曜日 午前８時２８分