Manuals / Bowers & Wilkins / TV and Video / Home Theater Screen

Bowers & Wilkins CT800 installation manual Front left/right channels

Models: CT800

1 31

Download 31 pages 44.22 Kb

Page 19

Front left/right channels

The DIP switches should be set as follows, where ON is down:

��

��	��
��	��
��	��

��	��	��
��	��	��
��	��	��
��	��	��

��

��

��

��

��

��	��	��
��	��	��
��	��	��
��	��	��
��	��	��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��

��	��	��
��	��	��
��	��	��
��	��	��
��	��	��

Examples of typical DIP switch settings at the front of the CT8 XO

Front left/right channels

ON

Left surround channel

ON

Right surround channel

ON

Centre channel

ON

These settings apply when all power ampliﬁers have the same gain, the parametric equalisers are bypassed, trigger switching is used to set the dipole/monopole mode of the CT8 DS speakers and one subwoofer is connected to each of the front left and right channels.

18

Image 19

Bowers & Wilkins CT800 installation manual Front left/right channels

Contents

CT800 Series Installation ManualTable of Contents Limited Warranty WarrantyHow to claim repairs under warranty WARNINGS Owner’s ManualIMPORTANT SAFETY INSTRUCTIONS Explanation of Graphical SymbolsPage Environmental Information IntroductionThe Concept Although the speakers are semi-active and require an active crossover, all power ampliﬁcation must be separately sourced. Each CT8 LR, CT8 CC and CT8 DS requires two channels of power ampliﬁcation, or three if used with a CT8 SW subwoofer. This allows the user maximum ﬂexibility in choosing these components Speaker Position Planning the installationSafety Warning Check the contents against Figure Planning the installationFigure 5Surround speaker dispersion mode ~60 oMounting the speakers speaker. ﬁgure for in the template must be made when cutting an aperture in the wallscrews head unit of the CT8 LR and CT8 CCSafety Warning Installation into drywall ﬁgureIn existing construction Installation to wall surface ﬁgure Continue for all cases The speakers Connecting the SystemCT8 DS only The CT8 XO crossover/equaliser The CT8 XO Rear PanelDescription of controls Description of ControlsFront left/right channels Conﬁgure the CT800 XO to the speaker Conﬁgure the unit to the gain of each power ampliﬁerSetting the LF gain Equipment RequiredConﬁgure the dipole lobe for a CT8 DS Setting the Subwoofer gainConﬁgure the equalisers The TheoryThe Method Laptop computer settings ProcedureSet the “Output” slider to zero and switch on the test signal by Click OK. The graphs will change, but ignore these changes Set Bank 2 Switches 2 & 3 according to the number of ﬁlters required Ancillary equipment Running In and Ancillary EquipmentAftercare Speciﬁcations CT800 system active bass management controller SpeciﬁcationsT +44 1903 221 ll09835 IssueUK Group UK Sales Dale Road