Manuals / Bowers & Wilkins / TV and Video / Home Theater Screen

Bowers & Wilkins CT800 installation manual Table of Contents

Models: CT800

1 31

Download 31 pages 44.22 Kb

Page 2

Table of Contents

Warranty	2
Owner’s Manual	3
Important Safety Instructions	3
Introduction	5
Environmental Information	5
The Concept	6
Planning the Installation	8
Checking the Contents	8
Speaker Position	8
Surround Speaker Dispersion Mode	9
Mounting the Speakers	10
Installing CT8 DS Into a Drywall	12
Installing CT8 DS to a Wall Surface	13
Connecting the System	15
The Speakers	15
The CT8 XO Crossover/Equaliser	16
Description of Controls	17
Conﬁgure the CT800 XO to the Speaker	19
Conﬁgure the Unit to the Gain of Each Ampliﬁer	19
Conﬁgure the Dipole Lobe for a CT8 DS	20
Conﬁgure the Equalisers	21
Running In and Ancillary Equipment	26
Aftercare	27
Speciﬁcations	28

1

Image 2

Bowers & Wilkins CT800 installation manual Table of Contents

Contents

Installation Manual CT800 SeriesTable of Contents How to claim repairs under warranty WarrantyLimited Warranty Explanation of Graphical Symbols Owner’s ManualIMPORTANT SAFETY INSTRUCTIONS WARNINGSPage Introduction Environmental InformationThe Concept Although the speakers are semi-active and require an active crossover, all power ampliﬁcation must be separately sourced. Each CT8 LR, CT8 CC and CT8 DS requires two channels of power ampliﬁcation, or three if used with a CT8 SW subwoofer. This allows the user maximum ﬂexibility in choosing these components Check the contents against Figure Planning the installation Planning the installationSafety Warning Speaker Position~60 o Figure 5Surround speaker dispersion modeMounting the speakers head unit of the CT8 LR and CT8 CC for in the template must be made when cutting an aperture in the wallscrews speaker. ﬁgureIn existing construction Installation into drywall ﬁgureSafety Warning Installation to wall surface ﬁgure Continue for all cases CT8 DS only Connecting the SystemThe speakers The CT8 XO Rear Panel The CT8 XO crossover/equaliserDescription of Controls Description of controlsFront left/right channels Equipment Required Conﬁgure the unit to the gain of each power ampliﬁerSetting the LF gain Conﬁgure the CT800 XO to the speakerSetting the Subwoofer gain Conﬁgure the dipole lobe for a CT8 DSThe Method The TheoryConﬁgure the equalisers Procedure Laptop computer settingsSet the “Output” slider to zero and switch on the test signal by Click OK. The graphs will change, but ignore these changes Set Bank 2 Switches 2 & 3 according to the number of ﬁlters required Running In and Ancillary Equipment Ancillary equipmentAftercare Speciﬁcations Speciﬁcations CT800 system active bass management controllerDale Road ll09835 IssueUK Group UK Sales T +44 1903 221