Part names
Part names
Projector
Remote sensor (15)
Zoom knob (18) | Speaker (6) |
Focus ring (18)
Vent (6)
Lens cover (16)
(Slide door)
Lens (16)
Lamp cover
(Lamp unit is inside.) (38)
Control buttons 
(See the following page.) (5)
Front-Right side
Bottom side
Elevator button (8)
Elevator foot (8)
Filter cover (40)
(Air filter and intake vent are inside.)
Power switch (16)
AC inlet (13)
Elevator button (8)
Ports
(See below.)
AUDIO OUT port (11) AUDIO IN1 port (11)
COMPONENT VIDEO ports (12)
Y
CB/PB
CR/PR
VIDEO port (12) AUDIO IN2 port (11) USB port (11)
Y
CB/PB
VIDEO
CR/PR
COMPONENT VIDEO
| Elevator foot (8) |
| Vent (6) |
Restart switch (*) (46) | |
| |
| RGB IN1 port (11) |
| RGB IN2 port (11) |
AUDIO IN1 | RGB OUT port (11) |
AUDIO OUTRGB IN1RGB IN2RGB OUT | |
AUDIO IN2 | CONTROL port (11) |
USB | Kensington lock slot |
CONTROL | |
Ports |
|
NOTE (*) About Restart switch: This Projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.
4
