SERVICE PROCEDURE
Burner Operation Inspection,
Cleaning and Replacement
BURNER CLEANING (Cont.)
Step 5. Disconnect (unscrew) manifold mount from feed line. Use a stiff brush, compressed air and/or shop vacuum to remove any debris build up from the manifold mount.
Step 6. Remove main burner orifice from feed line (3/8" wrench). Inspect and clean if necessary
Step 7. Remove pilot assembly, refer to SERVICE PROCEDURE
Step 9. Inspect combustion chamber area of heater prior to reinstallation of burner assembly. If cleaning is required, refer to SERVICE PROCEDURE
Step 10. Reinstall burner and inner door per SERVICE PROCEDURE
Step 11. To resume operation, follow the instructions located on the lighting instruction label or the lighting instructions located in the installation and operation manual.
Page 20
20