Braun NL955 manual 1500, Cycles

Maintenance and Lubrication Schedule

	Remove pump module cover and inspect:		Resecure, replace or correct as needed.
	•	Hydraulic hoses, fittings and connections for
1500		wear or leaks.
	•	Harness cables, wires, terminals and connec-
Cycles
		tions for securement or damage.
	•	Control board, circuit breaker, power switch and
		lights for securement or damage.

Perform all procedures listed in previous sections also

4500

Cycles

Inspect cotter pins on platform pivot pin (2).

Hydraulic Fluid (Pump) - Check level. Note: Fluid should be changed if there is visible contamination. Inspect the hydraulic system (cylinder, hoses, fit- tings, seals, etc.) for leaks if fluid level is low.

Resecure, replace or correct as needed.

Use Braun 32840-QT (Exxon® Univis HVI 26) hydraulic fluid (do not mix with Dextron III or other hydraulic fluids). Check fluid level with platform lowered fully and roll stop unfolded fully. Fill to within 1/2˝ of the bottom of the 1-1/2˝ fill tube (neck).

continued

Inspect cylinders, fittings and hydraulic connections for wear, damage or leaks.

Inspect outer barrier cylinder hose assembly (hose, fasteners, connections, etc.) for wear, damage or leakage.

Tighten, repair or replace if needed.

Tighten, repair or replace if needed.

Page 49