Terminal Strip and Door Operators
Terminal Strip
The
| 1 |
| 2 |
| 3 |
| 4 |
| 5 |
| 6 |
Black Jumper | 7 8 |
| 9 10 |
3RZHU'RRU2SHUDWRUV
Install optional power door operators as detailed in the instruc- tions supplied with door operator kit.
Route the wires to the pump module and connect to the termi- nal strip as shown.
To Door Openers
“Open” Trigger
|
|
| Orange |
Door Cutout |
| Black | |
Full Open |
| Red | |
|
|
| Blue |
|
|
| |
To Door Openers |
| ||
“Close” Trigger |
| ||
1 2 3 4 5 6 7 8 9 10
C_SW
O_RL
N/C
IN_LK
12_V
PWR
GND
F_LV
O_SW
C_RL
Floor Level and Inner Roll Stop Adjustments
$FKLHYLQJSURSHUÁRRUOHYHOSRVLWLRQLQJRIWKHSODW- form and inner roll stop requires a combination of )ORRU/HYHOVZLWFKDGMXVWPHQWDQGLQQHUUROOVWRS adjustment. Both are factory set but must be in- spected during installation procedures (will vary per vehicle application).
Ensure the lift is positioned and secured as speci- ÀHGRQ4XLFN5HIHUHQFH,QVWDOODWLRQ6KHHW VXS- plied with lift) panels 1 and 2. Adjust the Floor Level switch ÀUVW(detailed below). Then, adjust the inner roll stop as detailed in Inner Roll Stop Adjustment Instructions (adjust only if necessary). The inner roll stop must rest properly on the vehicle ÁRRUIRUZKHHOFKDLUHQWU\DQGH[LW
Floor Level Switch Adjustment
Adjust the Floor Level switch ÀUVW (before adjusting the inner roll stop)!
7KH)ORRU/HYHOVZLWFKVWRSVXSZDUGWUDYHORIWKH platform during the Up function (activated by the WRUTXHWXEHPRXQWHG)ORRU/HYHOFDP
Position the bottom of the lift platform 1 1/2" above ÁRRUOHYHO WKUHVKROGPDW using the manual op- eration system. 'RQRW operate the lift with the electric pump during adjustment procedures.
Loosen the clamp securing the torque
1RWH &KHFNWKHÁRRUOHYHOSRVLWLRQRIWKHSODWIRUP and the inner roll stop after powering the pump. Hydraulic pressure may affect platform height VOLJKWO\)LQHWXQLQJDGMXVWPHQW WZHDNLQJ RIWKH )ORRU/HYHOVZLWFKPD\EHUHTXLUHG
)ORRU/HYHO&DP | )ORRU/HYHO6ZLWFK |
A |
Torque Tube | Cam depressing switch. |
Page 6
