Certification Checklist Diagnostic Procedures
7KHIROORZLQJRSHUDWLRQVDQGFRQGLWLRQVPXVWEHIXQFWLRQDOO\YHULÀHGLQRUGHUIRUWKHOLIWWREH)0966 403/404 compliant. If an operation does not function as described or a condition is not met, follow the refer- enced procedures to correct the problem or contact a Braun Corporation Product Support representative at 7+(/,)7®.
9HKLFOHPRYHPHQWLVSUHYHQWHGXQOHVVWKHOLIWGRRULVFORVHGHQVXULQJWKHOLIWLVVWRZHG
9HULI\OLIWVWRZHGVLJQDO SLQ LQWKH FRQGXFWRUSOXJRQWKHVLGHRIWKHSXPSPRGXOHKDVDYROW signal.
2.Refer to the interlock installation instructions.
•Lift operation shall be prevented unless the vehicle is stopped and vehicle movement is prevented.
9HULI\YHKLFOHVHFXUHVLJQDO SLQ LQWKH FRQGXFWRUSOXJRQWKHVLGHRIWKHSXPSPRGXOHKDVD volt signal.
2.Refer to the interlock installation instructions.
•The platform will not fold/stow when occupied.
-Refer to Platform Sense Calibration.
•The inner roll stop will not raise if occupied.
-Refer to Inner Roll Stop Occupied Sensor Adjustment
•The outer barrier will not raise if occupied.
-Refer to Outer Barrier Occupied Calibration procedure
9HULI\SODWIRUPOLJKWLQJZKHQOLIWLVGHSOR\HGDQGSHQGDQWLOOXPLQDWLRQZKHQOLIWLVSRZHUHG
1.Replace bulb(s) in the light housing.
2.Check inline fuse on wires going out to lights.
•A visual and audible warning will activate if the threshold area is occupied when the platform is at least 1"
EHORZÁRRUOHYHO
1.Make sure connectors to threshold mat are properly connected.
2.Call Product Support.
•Platform movement is prohibited beyond the position where the inner roll stop is fully deployed (up).
-Call Product Support.
•Lift platform movement shall be interrupted unless the outer barrier is deployed (up).
-Check Barrier Down limit switch, wires and connector.
-LED D29 should not be illuminated when outer barrier is deployed (up).
Page 4
