Troubleshooting Diagnosis Chart
| FUNCTION | 
 | POSSIBLE CAUSE | REMEDY | |
| 
 | 
 | 
 | 
 | |
| 
 | 9.11 | Bad circuit breaker | Check for proper operation of Below Stow switch. | |
| 9.00 | 9.12 | Poor plug connections | Remove weight from platform. | |
| BARRIER WILL | ||||
| 
 | 
 | 
 | ||
| NOT OPERATE | )DXOW\EDUULHUDFWXDWRUPRWRURU | Check harness connectors A1 and A2, E1, N1, | ||
| UP OR DOWN | ||||
| 
 | actuator out of adjustment | 1()DQG)&KHFNSRZHUDWPRWRU$G- | ||
| WITH REMOTE | 
 | |||
| 
 | 
 | just or replace actuator if necessary. | ||
| OR OVERRIDES | 
 | 
 | ||
| 
 | 
 | 
 | ||
| 
 | 9.14 Bad power and ground | See 1.00 | ||
| 
 | 
 | 
 | 
 | |
| 
 | 
 | 
 | 
 | |
| 10.00 | 10.11 Barrier Down LED (D29) | Check Barrier Down switch for proper operation | ||
| BARRIER | ||||
| OPERATES WITH | 
 | not illuminated | with LED on P.C. board. Replace or adjust as | |
| OVERRIDES BUT | 
 | 
 | necessary. | |
| WILL NOT GO UP | 
 | 
 | 
 | |
| WITH REMOTE | 
 | 
 | 
 | |
| 
 | 
 | 
 | ||
| 
 | 
 | 
 | ||
| 11.00 | 11.11 Ground sensor LED (D23) | Check Pressure Transducer. Replace or adjust | ||
| 
 | not illuminated | as necessary. See Ground Sense Calibration on | ||
| BARRIER | 
 | 
 | page 5. | |
| OPERATES WITH | 
 | 
 | 
 | |
| OVERRIDES BUT | 11.12 Below Stow LED (D24) | Check Below Stow switch for proper operation. | ||
| WILL NOT GO | 
 | not illuminated | Replace or adjust as necessary. | |
| DOWN WITH | 
 | 
 | 
 | |
| REMOTE | )XOO2XW/('' | &KHFN)XOO2XWVZLWFKIRUSURSHURSHUDWLRQ | ||
| 
 | 
 | not illuminated | Replace or adjust as needed. | |
| 
 | 
 | 
 | 
 | |
| 
 | 
 | 
 | 
 | |
| 
 | 12.11 | Improper terminal block wiring | Check terminal block for correct wiring | |
| 
 | 
 | 
 | FRQÀJXUDWLRQ | |
| 12.00 | 12.12 No power going to switches | Check power on connector A1, pins 1 and 2. | ||
| SWITCHES | )DXOW\ZLULQJ | Check continuity of wires from switches to | ||
| DO NOT | ||||
| ACTIVATE | 
 | 
 | connector A2. | |
| 
 | 
 | 
 | ||
| LED(S) | )DXOW\FRQQHFWLRQV | Check for proper connections on each switch and | ||
| 
 | ||||
| 
 | 
 | 
 | on each connector on the harnesses. Replace | |
| 
 | 
 | 
 | contact if necessary. See diagram on following | |
| 
 | 
 | 
 | page. | |
| 
 | 
 | 
 | 
 | |
| 
 | 
 | 
 | 
 | |
| 13.00 | )DXOW\ZLULQJ | Check for proper wiring to door openers. | ||
| DOORS | ||||
| DO NOT | 
 | 
 | 
 | |
| OPEN | 
 | 
 | 
 | |
| 
 | 
 | 
 | ||
| 14.00 | )XOO2XW/(''LOOXPLQDWHG | Lift is out but not below stow level. | ||
| 
 | and Below Stow LED (D24) | 
 | ||
| DOORS | 
 | not illuminated | 
 | |
| DO NOT | 14.12 Lift Out LED (D25) illuminated | Lift not stowed fully. Adjust Lift Out switch. | ||
| CLOSE | ||||
| 
 | 
 | 
 | 
 | |
Page 17
