Braun NUVL855R service manual Inner Roll Stop Adjustment

&$87,21

'RQRWDGMXVWLQQHU UROOVWRSOLQNDJHURG /LQNDJHURGDGMXVW- ment may result in lift damage.

Floor Level and Inner Roll Stop Adjustments

Inner Roll Stop Adjustment

'RQRWDGMXVW inner roll stop OLQNDJHURGDW WKLVWLPHLink- age rod adjust-

ment is not required unless extra usable platform length is needed. If the

angle of the inner roll stop (when in the vertical position) restricts the usable platform length for the wheelchair passenger, adjustment of the linkage rod will change the angle.

With the platform at ground level and the inner roll stop in the vertical position, there should be a minimum of 1" clearance between the in- ner roll stop and torque tube. See photo I.

Adjust the inner roll stop as detailed in the following procedures. Then, adjust the linkage rod as detailed on page 9 (only if necessary).

1.5DLVHWKHOLIWSODWIRUPIXOO\ÁRRUOHYHOus- ing the manual operation system (Manual 2SHUDWLQJ,QVWUXFWLRQVGHWDLOHGRQ4XLFN Reference Installation Sheet). If the inner UROOVWRSUHVWVSURSHUO\RQWKHÁRRUdo not adjust the inner roll stop. Lower the platform to ground level. If the angle of the inner roll stop (when in the vertical position), does not restrict the usable platform length for the wheelchair passenger, disregard inner roll stop adjustment procedures. See Photo G on page 9. Refer to the following procedures if adjustment is required.

2.Position the lift platform ap- proximately 12" above stow level using the manual operation system. See Photo C.

Raising the platform will allow access to the cam securement screw and nut. See Photo E.

Inner Roll Stop

B

Linkage Rod

0DQXDO2SHUDWLRQ6\VWHPV

T-Handle		VALVE		Hand
Release				Pump
Cable	N		C
				L
	E			O
	P			S
	O			E

	Pump	9DOYH
Figure A	Handle

Stow Level

Platform

12"

above

Stow

Level

C

Page 7