Breville BEM800 manual Troubleshooting Guide, Possible Problem, Easy Solution

TROUBLESHOOTING GUIDE

POSSIBLE PROBLEM	EASY SOLUTION
	• Always ensure the speed control dial is in the “Off”
	position before start.
Machine will not work	• The “thermo cut-off – Temperature Overload”
when switched “ON”	protection device has not been activated automatically,
	allow more time for the motor to
	cool down.
Cannot set the time on the	• Always ensure the speed control dial is in the “Off”
Count-down timer.	position before trying to set the count-down time.
	• The mixer has been stressed by overloading or
	stalling. The mixer will automatically activate the
Mixer suddenly switches	overload protection button and the unit will switch itself
	off. When this happens it is recommended that the
off during mixing	unit is switched off at the power outlet
	and unplugged. The safety devices will the be
	reset and the Breville Wizz planetary mixer is ready to
	use again.
	• The mixer will automatically stop operating if the motor
	is stalled. If this occurs, the ‘E1’ error message will
	flash on the count-up/down timer display. This is an
“E1” error message is	electronic safety feature. This is normally a result of
	too much ingredients being processed at one time. Try
flashing on the count-up/
	removing some of the ingredients from the bowl. To
down timer display
	continue mixing, turn the speed control dial to the off
	position and unplug the mixer from the power outlet.
	Then plug the mixer into the power outlet and use as
	normal.
	• This may indicate that the motor has been stressed
	by overheating with excessive load. The mixer is fitted
	with a self-resetting safety device which safeguards
	against overheating on the motor with excessive loads.
“E2” error message is	If overheating occurs, the mixer will automatically
	activate the overheating protection device and the
flashing on the count-up/
	motor will switch itself off. When the overheating
down timer display.
	protection is activated, unplug the mixer from the
	power outlet for at least 15 minutes to allow the unit to
	cool. Turn the speed control dial to the “Off” position
	then plug the mixer into the power outlet and use as
	normal.
	• When ingredients are in the mixing bowl, the scraper
Noise is heard	beater may make a slight noise as it scrapes the sides
	and bottom of the bowl. This is normal and should
when scraper beater	not cause concern. Do not turn the mixer on with the
is mixing	scraper beater in place if the mixing bowl is empty.
	This will cause the scraper beater to make a loud noise
	as it scrapes the bowl.

37