Breville BEM800 manual Assembly and Operation of Your Wizz Planetary Mixer continued

Assembly and Operation of Your Wizz® Planetary Mixer continued

itself off. Should the mixer go into this mode, the LED indicator band will flash and the error message “E2” will flash on the LCD screen and the buzzer will “beep” 3 times.

If this error occurs, turn the speed control dial to the ‘Off’ position, switch the appliance off at the power outlet and unplug the cord. Wait at least 15 minutes before restarting the mixer.

Electronic Protection Cutoff – Current Overload

The mixer is equipped with an electric protection cutoff and will automatically stop operating if the motor is stalled or overloaded. This is normally a result of excessive ingredients being processed at one time. Should the mixer go into this mode, the LED indicator band will flash and the error message “E1” will flash on the LCD screen and the buzzer will “beep” 3 times.

If this error occurs, turn the speed control dial to the ‘Off” position, switch

the appliance off at the power outlet and unplug the cord. Remove some of the ingredients in the mixing bowl and then restart the mixer.

Disassembling the mixer

1.When mixing is complete, turn the speed control dial to the ‘Off/Stand by’ position, switch the appliance off at the power outlet and unplug the cord.

2.Remove splash guard if assembled. Separate pour spout then slide main ring out of position.

3.Raise the mixer motor head by depressing the tilt back button and lift the mixer motor head up until it tilts back and locks into the open position.

4.Remove the beater/dough hook/whisk attachment by holding the mixer motor head and pressing the attachment upwards on the spindle. Turn the attachment anticlockwise to release it from the pin on the spindle.

5.Use a soft plastic spatula to remove mixture from the beater, dough hook or whisk attachment.

NOTE: When lowering or lifting the mixer, always support the motor head with your other hand to prevent from free-falling.

6.Remove the mixing bowl from the indented bowl locking recess of the mixer Base and turn anti-clockwise until the bowl releases. Use a soft plastic spatula to remove mixture from the mixing bowl.

7.Lower the mixer motor head by depressing the tilt back hinge button and pushing the mixer motor head down until it locks into the horizontal (closed) position.

15